Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,
have set up two routers for ipsec vpn is see the folowing on R1:
R1#sh crypto isakmp saIPv4 Crypto ISAKMP SAdst src state conn-id statusx.x.x.241 x.x.x.197 QM_IDLE 1007 ACTIVEIPv6 Crypto ISAKMP SA
...
hi,
i have a 1941 router configured with a zone based firewall. All working fine except the smtp.
we can reseive mails trough pop3 and imap but cannot send trough smtp. I get the following drop to see.
"dropping tcp session x.x.x.x:63025 x.x.x.x du...
I want to allow teamviewer.
following zones are already in there:
LAN with G0/0.1, G0/0.10 G0/0.20 and G0/0.30
WAN with G0/1
VPN
DMZ
anyone who can show me how to do this?
Hi,
i was setting up a new router but it looks impossible to ping outside. Here is my run conf.
Current configuration : 6548 bytes!! Last configuration change at 10:05:20 brussel Tue Jun 6 2017 by benny!version 15.6service timestamps debug datetime m...
Hi,
i have a wireless network with 5 WAP371 devices. On 3 devices i get 1000M but 2 only use 100M. The color on the WAP for the connection is orange.
They all connected to the same SG300-52P Gigabit switch.
All settings for the ports are the same.
I...
yes this is correct, i also find my problem
i was pinging from the routers itself and not from a pc. it is working wel from the desktops in the networks.
Thank you for the support!
Best regards,
Benny
I did so i think without succes no ping possible after clearing vpn tunnel.
On
R1LnkOever:sh crypto map Interfaces using crypto map NiStTeSt1:Crypto Map IPv4 "VPN-C-MAP" 10 ipsec-isakmp Peer = x.x.x.241 Extended IP access list VP...
Hi,
that does not work, but how the traffic knows where to go do i need to setup some static routes for the nv1 or so?
This i see when i run sh access-lists
Extended IP access list 100 10 deny ip 192.168.1.0 0.0.0.255 192.168.11.0 0.0.0.255 (11...
this is what i get on logs.
*Nov 6 20:15:21.178: %APPFW-6-NBAR_PORT_HOP: smtp using 587 port - tcp session 192.168.1.117:63759 212.71.0.16:587 on zone-pair LAN-WAN class OthersR1(config-if)#*Nov 6 20:15:35.210: %FW-6-DROP_PKT: Dropping tcp sessi...
