Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've created multiple VPN groups for different groups of remote access users on the ASA. Authentication is done via a Cisco ACS server.Is there a way to identify on the ACS server which VPN group an user is authenticating from?
Hi,I've an existing WLAN network of about 15 APs running WPA. The number of APs is expected to increase to aboute 30-50. As I would like to have better RF & AP management and also rouge AP detection & suppression, I'm looking at getting either gettin...
Hi,I've 2 PIX 535 with UR license. After upgrading them to support 3DES/AES, one of them is now showing that it only has a Restricted license!!!Have anyone faced the same problem as me? Can someone shed some light on this?Kenneth
Hi,I've a central PIX which is connected to 2 remote sites via 2 site-to-sites IPSec tunnels. Both these 2 tunnels are terminated on the same outside interface on my central PIX. Is it possible for me to configure the 2 remote sites to talk to each o...
hi, but this reflects the group the user is mapped to. What I would like to know if the which VPN group on the ASA is the remote user is authenticating from.
hi steve,this command encrypts all password in the configuration. What i need is for the password to be masked when i key in at the console during the startup EasyVPN tunnel. Can anyone help?
