Hi,How do I configure a router to support RLOGIN incomming connections.I configured line vty 0 4 login local transport input allI have some username's confilgured in the routerwhen I try to rlogin to the router I get connection refused.I did a debug....

I have the following config:IBM PCOM on E0 <-> CISCO 2600 12.3  <-> CISCO 7500 12.2 <-> SNASW <-> M/F------------------------------------------------------------------------------<->  CIP LAN Tok <->  M/FCISCO 2600 Configsource-bridge ring-group 200d...

Hi, Does the 2621 Router support SSH login to the router? I have 12.3.26 Enterprise installed but could not configure SSH. If I need IP/PLUS I will have to upgrade the Flash to 32Meg. I also need IPv6 and SRB support.

We put a 64Meg Flash Disk in a 7500 RSP4. The device came active and seems to work. The CISCO doc indicates thar Flash Disk are not supported on RSP4 but is supported on RSP4+ . Am I taking a risk trying to use the Flash Disk on the RSP4 ?

I am trying to bridge LLC2 traffic through a CAT 4500 Switch running IOS. Will LLC2 be passed through a VLAN or do I need to configure the switch to pass LLC2 among specific switch ports with bridging commands?