Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I am setting up a guest network on a EWC with a Catalyst 9115AXI AP, software version 17.9.4aGuest user works good, but when I try to log in with a Lobby Admin user, an error is shown. In the Access Point log, there is a log message confirming...
Hello.Since your AP has obtained an IP address from a DHCP server, I am curious: For what reason do you need access to the AP shell? To change what?Remember that on my scenario, there was no DHCP server, so it was required to assign a static IP addre...
Hi, which model is your AP and what software version are you running on it? I also agree with @Rich R a factory reset could help. You can use the "setup" command in privileged mode or alsowireless ewc-ap factory-resetFinally, it is possible that you ...
Hello @byxbeklaeddblottbaktill it is recommended to do these configurations connected thru console cable. Take into account that this guide is intended for first time setup or in an environment where you don't have access to the EWC GUI either locall...
For anyone that tried every step in this guide and still cannot ping and log in to the EWC, here is what worked for me:Scenario:- No DHCP server, EWC uses static IP address. - Tried to access GUI with AP directly connected to a PC with Power Injector...
