Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Received a couple pieces of equipment to test.1. Cisco RV3202. Alcatel W800 (T-Mobile)Trying to connect the W800 to USB1 on the Cisco RV320. Not able to get to recognize it.Is this device compatible with the RV320?The W800 works well when connected ...
Bear with me as I cut/paste information gathered while trying to find a solution to our agency issue.Platforms: Cisco 2821 Router & Cisco 2911 RouterWill provide IOS level/revision at the start of each segment.Problem discussion: We use TACACS+ to...
Trying to figureout what I'm doing wrong. Have a Cisco 2821 router with Fan 3 not rotating. SNMP setup to trap on fan status, but the state shows to be shutdown and not failed as the router messages would indicate. The router is at a very remote l...
This is as much as I can provide.aaa group server tacacs+ TACACS_GRP1 server 10.x.x.x server 204.x.x.x.x server 204.x.x.x!aaa authentication login default local group TACACS_GRP1 enableaaa authentication login local group TACACS_GRP1 enableaaa authe...
Thank you for the reply.We are using an ACS appliance Build ID: B.221 with Patches: 5-4-0-46-5 Not sure what upgrade other than what we are at is available??Authentications works great! Authorizaton fails!IOS 15.0.x works fine with the above ACS...
Thx for the info!I did walk the MIB a bit more and found the envmon+fan+statuschangeRouter snmp-server fan status change enabled.Now I receive this message on the monitoring station:ciscoEnvMonFanStatusChangeNotif.0 Response packet contained the er...
