Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I'm running a Fabric with 3 APIC, some Leafs Spines and PODs devices.I set a policy to authenticate to the Fabric through Radius, which are running on windows NPS servers.Authentication to APICs succeeds without issues but I cannot authenticate...
Hello,I'd like to create a span session in my ACI infrastructure, typically from my proxy appliance attached to physical port on a LEAF toward a remote VM acting as a sniffer receptor, running Wireshark.I have tested few methods for configuring SPAN ...
Hello All, I need to purchase new materials such as 9300 and 9500 catalyst platforms.I clearly need the functionnalities listed in the Network essentials for my access switch (9300 series) and Network Advantage for my distribution and core switches (...
Hello,I have few stacks of 2960S, generally built as following, and running the following version.Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 52 WS-C2960S-48L...
Hello,I need to authenticate a trunk port (with dot1x) where runs a development machine which hosts Virtual Machines.So, the port where is connected the machine is a dot1q port.Therefore I'd like to authenticate this machine with DOT1x, and by now it...
Your'e right, in fact I've mistaken with the source IP/prefix.Since I've set the good prefix I can see the gre packets arriving on my sniffer.Many thanks for the support.Kind regards,Gildas
Hello,I've set a the destination BD as L3 but it doesn't work.I can't see incoming packets and no GRE packets neither.Do I also need to set the source BD as L3?Did I forgot a step? At this point I can't see any fault when applying the SPAN policy at...
Hello, I did the change of the destination IP without prefix, but it doesn't fix the issue, no GRE traffic toward my destination sniffer.Kind regards,Gildas
Hello,Ok, so if I good understand I need to set my destination BD as L3.I have few questions about it.When I set the BD in L3, a pervasive gateway will be published. But now my Gateway is a firewall cluster and must remains the firewall, so I guess t...
Hello Sergiu,Thanks for your quick reaction, you can find here below further information about my policy.At my knowledge, source and destination BD are set in L2 because hosted behind a firewall.Indeed, in source, I've selected the DMZ Tenant and did...
