Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone configured Citrix Web Interface access via ASA WEBVPN (ASA 8.2)?I can access the Citrix Front End but when I select an Application I get a message saying there is no server configured at that address.Any help appreciated.
Can the loadbalancer provide type 301 (permanent) redirects instead of 302's which are temporary.Also can a redirect retain a variable identifier in a rewrite rule eg :-http://www.test.co.uk/search/story/?story_id=2234160 to Redirect to new format: h...
If I use Multiple set peer statements in a crypto map on an IOS router to allow redundancy will the router be allowed to both initiate and accept connection requests?On an ASA multiple peers can only be used with the initiate-only connection type.
Hi.Has anyone set up ACS security for SSL/Webvpn Tunnel Groups on the ASA.I want to set up multiple tunnel groups for different SSL VPNs and control Authentication via ACS.How do I ensure that when the user has Authenticated, he can only access a par...
There is no special config on line con 0.
The tacacs server timeout is set to 5 seconds as below:
tacacs-server host 192.168.1.1 timeout 5tacacs-server host 192.168.1.2 timeout 5
I was not able to login therefore was not able to turn on debugging.
Hi Kureli - I am a bit confused when you say you cannot load balance.The document says "Defining more than one equal cost default route entry causes the traffic sent to the default route to be distributed among the specified gateways."Surely if I am ...
Hi Kureli.The ASA 8.2 documentation suggests you can load balance between 2 ISPs.Please see the following: Configuring a Default Static RouteA default route identifies the gateway IP address to which the adaptive security appliance sends all IP pack...
