Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We plan to have BFD configured but with following conflicting parameters due to different support groups and standards:CE Router: bfd interval 300 min_rx 300 multiplier 3PE Router: bfd interval 500 min_rx 500 multiplier 5Per my understanding, the hea...
All,I need to configure BFD for a WAN link and enable it under the BGP as well both on CE and PE routers.Due to different teams managing either side of the WAN link, the change on one side (PE) will take place first while the change on other side (CE...
Hello,I have a Cisco 3750 switch with IOS 12.2(50)SE2. I have an SVI for a vlan 20 which is currently in up/down state. I have been told that it was working until last month. When I do a show vlan or show vlan id, I do not see the vlan 20 in the data...
Hello,I have a single user scenario at far end using both data and VoIP with VoIP being critical. Should I stick with Remote access or should I expect better performance with Site to Site VPN? This is with same DSL speed to Internet.Thank you,Nadeem
Is this feature, to extend Layer 2, only supported on Nexus 7000? In fact I need to know in particular if this can be implemented on Cisco 3750 switch and/or ASR1002 router?I appreciate in advance for your help with this.
Thanks for the help. I added the vlan and it fixed the problem.Still do not know what caused it to begin with.Jon,It is running VTP server mode.Thanks again,Nadeem
Rahul,I really appreciate the quick response.Just one more question in this regard:Any major technical difference between 4948-E and 4948E. Both are available on ordering tool as separate.Thanks again,Nadeem
Thanks. I'm looking for some figures to justify keeping 7206 NPE-G2's. Not sure how can I find if there is a threshold on the amount of real time traffic both of these routers can handle.
Also look at your QOS and ACL configuration as this consumes most cpu utilization. See if you can reduce that configuration. If you can not, ASR may be a good option in your case as it does hardware switching.
