Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My debug gives the following error. There are no problems getting from the router to the acs server. Please helpOct 5 09:59:56: TPLUS(00000AB6): Start write failedOct 5 10:00:01: TPLUS(00000AB6)/0/WRITE/6273894C: timed outOct 5 10:00:01: TPLUS(000...
Hi. I have two PIX 515E firewalls. Each has a connection to a router via the outside interface and on the inside to two Cat 6506's. The PIX's are connected via a failover cable and is stateful. I have an ISDN router on a DMZ on the primary PIX, which...
I'm using a 3640 as NAS with aaa and ACS for windows. When my NAS is restarted my multilink interface does not come up, all other (HDLC and dial async etc)come up and are active. Error on ACS under failed attampts is "bad request from NAS". This sit...
Hi. I have a Cisco 6506 and have VLANs configured. Access layer switches, 3548 / 3524 are connected to the 6506 via Gig trunk (802.1q) links. Management VLANs are configured on the access switches. When doing a show of the interface VLAN x on the acc...
Hi. Thanks, both ways work well, however as you stated there is now still a single point of failure. I may look at upgrading the router at some later stage. Thanks once again.Vids
