Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi; We enabled Bpduguard on our access layer switches and enabled SNMP Traps for errdisable. Eventhough i can see them sending traps i can't see them on ciscoworks. So can someone help me on creating a Notification Trap on Cisco LMS3.2I can see all...
We are trying to configure VRFs in our network which has VSS6500 and 2960s. So can anyone help me out in finding the appropriate configuration documents for the setup.
When i powered the switch this is the error message it was displaying " !!! WARNING: The switch is not usable !!! " and it erased the complete config. It was on the network and was working alright until we took off today.Any help with this will be go...
Hi Guys, We planning in deploying QOS in our network and due to the size of our network we are planning to buy the QPM module for Cscoworks. But initilally i need to make some notes of the advantages of it to my team leader. Did anyone use it, if so...
Hi Clarke; Thanks alot for the help. Instead of running reports everyday and checking the syslog messages.Is there any other way to pro-actively report the err-disabled ports.Thanks in advance.Regards;Rams
Hi Tim; Eventhough you configure preempt, if you haven't did a copy-run-start it will disable the preempt command so that the active switch will not loose the running config. so try copying the running config to startup and it should work normally...
