09-04-2009 06:51 AM - edited 03-06-2019 07:36 AM
When i powered the switch this is the error message it was displaying " !!! WARNING: The switch is not usable !!! " and it erased the complete config. It was on the network and was working alright until we took off today.
Any help with this will be good.
09-05-2009 12:29 PM
Hello,
Personally, I have never ecountered a similar message. However, I can confirm that it is present in the IOS image for 2960. I suspect that it is displayed when one or more POST tests fail.
Does it appear every time you boot the switch? If yes, watch closely for the results of the POST tests. Also you can enter the command "show post" in the CLI to see the results after the switch has booted. If there are some POST failures indicated, the switch needs to be replaced.
Best regards,
Peter
09-06-2009 02:44 PM
Contact Cisco TAC and have the appliance replaced.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide