Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to add a 4 port FE cards to both my primary and failover PIX 515E's and I need to do it with as little down time as possible. Can I bring down the failover PIX first and add the card to it and then connect everything back up and have the prim...
I have a PIX 515E with a 4 port FE card and an ASA 5520 with 4 GE interfaces and I need to know if I can enable isakmp on two interfaces on the same firewall. I have included a drawing for a little better understand of what I am trying to do.
I have two locations that connect up to an MPLS cloud via a DS3 at one site and an OC3 at the other site as well as a local fiber connection between the two of them. I am using BGP for my routing in the MPLS cloud. The circuit between the two sites...
I have 6 sites that connect up to an MPLS network and two of those sites have a 500Meg TLS ethernet connection between them. I am trying to get all the routing between all the sites to be dynamic for redundancy and failover. All the sites that conn...
I was wondering if there is a way to set up Ciscoworks to remove old devices from the database once it's not detected for certain period of time. Like if I remove a device from the network is there a way to tell Ciscoworks to remove that device if ...
It looks like you may have either a bad spot in your RAM. If the code was corrupt it would even boot it would fail on the checksum when it boots. I would diffently call TAC and see what they say.
You answered my question thank you very much. I am running 7.2 code on my PIX 515E's and I didn't have one to test and verify if I could or not. Once I get my VPN tunnels up between the firewall I will be running GRE tunnels from the core 6509's an...
