Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently have a Pix 515E firewall that sets between a Catalyst 4006 on the inside and two 3745's with internet access configured as HSRP peers on the outside. We upgraded the firewall to the new 7.0 version of software and we started to have inte...
I currently have a Catalyst 4006 that we upgraded the weekend before last to the new 12.2.25 code to bring it up to date. We didn't have any high CPU utilization before however now we do. It started around 40% which was acceptable but now it's in the...
I currently have two 3745 Routers that I would like to take the built in fast ethernet interfaces and configure them for etherchannel. I have run into a problem however. I can create the port-channel interface and I can also add the fast ethernet int...
I currently have a Cisco model 3845 router. I installed the following network module, NM-HDV2-2T1/E1, in the router. Here's my problem. The onboard T1/E1 controllers do not show up on the router. If I stick a VWIC controller in the slot on the networ...
Unfortunately I can't do that in the current setup. I would really like to use etherchannel but unfortunately it seems that I just can't get it to work.
Would this high processor utilization affect the throughput of the switch? The reason I ask this is we just took out an HP Procurve and put in a Cisco 48 port 2950 Catalyst and the users are complaining of some slowness now that we haven't heard abou...
