Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After I reset the controller to factory defaults and go through the CLI config wizard, the mgmt ports (no matter which one i assign) do not work. I can not ge to the GUI after if i do a config network webmode enable. I can see the IP address through ...
I have a 2106 controller that I've been able to configure using the console port and enable the GUI. Its my understanding that the 1141's need the controller to be able to be configured, however, when I connect them to the 2106 I can see the waps but...
I just set the vlan to 0 (untagged) and configured port 1 for management, set an IP and i can ping it beautifully through cmd.I then reset it, set the vlan to 5 and configured port 5 for management and can not ping it.I guess for what we are using it...
