Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have attached a diagram of a proposed network.I need to route all VoIP traffic through R1, which is no problem.However, the client wants a failover solution so that if the serial link on R1 goes down, voice and data will fail over to R2. Conversely...
I am having a problem setting up IRB between two 1721's on a PPP link. The routers see each other fine, but they cannot see the switches that they are respectively connected to (via ping).The switches also do not show up in the router's ARP tables.He...
I've got 2 2620s connected via a point to point link and running OSPF. In one location I've got 2 VLANs, one for voice and one for DATA. I need to route or bridge those to the second location, as I am putting phones there as well.Do I just use a BVI ...
I am setting up a 2801 with QoS for VoIP. The following QoS config works fine on 1721s, but we are having issues with outbound voice on the 2801s with this policy. The IOS is 12.4(9T)ipbase.policy-map QoS-Policy class VoIP-RTP priority 512 class cla...
I have a verified connection on ADSL & my laptop connects fine using the supplied PPPoE credentials. The router does not connect using the WIC-1ENET or on board FastE. I'm continuously getting "Authentication Failed" even though we know the ID is c...
It's not call manager - it's all skinny back to my core through either connection to an asterisk system. Both serials are PPP. I can run any other protocol necessary between the 2 routers.There are no POTS, and, yes, they need to register and make ca...
Rick-I figured out a way to do this. Apparantly this arp issue was by design, as the BVI is the only interface being used, and an arp won't be sent out the same interface it was received in. I think that's what it was, anyway.So, I got rid of the BCP...
I would recommend trying a different rev of IOS. Since I see that the switchports are taking the "no ip address" command it looks like maybe you have a layer 3 IOS on there? I've seen problems arise from this on 2950s before.Are all of your switches ...
Rick-I have a client who is doing file/printer sharing across a PPP link, and this is how they originally had the routers setup.Now I need to have a voice/mgmt VLAN exist across this link, and they don't want me to get rid of the bridging setup. AFAI...
