Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,On a Cisco router, I can specify how much bandwidth each class gets, like this:Router(config)#class-map test
Router(config-cmap)#match cos 3
Router(config-cmap)#exit
Router(config)#policy-map test
Router(config-pmap)#class test
Router(config-pmap-...
Hi,On the lower-right side of the back of a Cisco 1861 router, there are two ports which I'm unsure about. On page 8 of the following PDF, they are referred to as an "FE port" and a "LAN Uplink" port: http://www.cisco.com/en/US/prod/collateral/rout...
Thank you very much for the explanation, GRinch! That makes perfect sense, and it is very informative. But I wonder what the FE port does, to the left of it? In the PDF, I can almost make out "WAN" underneath it.Regards,Richardhttp://www.advantage-co...
