Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
TopologyIXIA-----------Juniper PE------------P------------------CiscoME6524 (gig port running Xconnect).This is with refrence to the above topology, I want to run xconnect from Cisco to juniper. On the same port where I am running xconnect is it pos...
When refreing to the below link.http://www.cisco.com/en/US/docs/switches/metro/me3600x_3800x/software/release/12.2_52_ey/configuration/guide/swoam.html Ethernet CFM is an end-to-end per VLAN Ethernet layer OAM protocol that includes proactive connec...
There wont be any conflict in labels. Service provider exhange labels to customer routers but for custoemr router SP adds one more label to carry the customer routes from one PE to other, this can be done using MP-BGP.say for example PE1-----------...
Labels are distributed to other routers by protocols named LDP and TDP which is cisco specific where LDP is an open standard.http://www.faqs.org/rfcs/rfc3036.htmlTake for example three routers R1--------------R2-------------------R3.When I enable ld...
An Ethernet Virtual connection is defined as an instance of an asscociation of two or more UNI where the UNI is the standard ethernet interrface that is the point of demarcation between customer equipment and service provider MEN.Basically this techn...