Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 2 Cisco Nexus 5548UP with old firmware 5.2.1.N1.7We had 2 monitoring systems : OpenNMS (polling every 5 minutes) and LibreNMS (polling every 9 minutes). Every 24 hours one of the two Nexus have CPU peaks due to SNMPD process and we see port f...
We have a WLC-9800 controller and a lot of access points yet connected (Cisco 9115 ax).We'll need to configure another "bulk" of access points (dozens); at the moment we configure them manually (power on, find it on the controller, edit the configura...
We have successfully configure remote span in out network. The chain is something like that:vlan to be monitored -> cisco 9200L -> Nexus 5548 -> cisco 9200L -> destination portIn some cases , instead, we have this layout:vlan to be monitored -> cisco...
We have Cisco switches (Catalyst 9200L) ad we have successfully configured remote span (RSPAN) for some source ports to a single remote PORT.Is it possible to remote span an entire VLAN without configuring every single port of every switch?Thanks
We have some 2 Cisco Nexus 9300 and 2 Cisco MDS 9148.We have configured Radius authentication in the same way but it works only on Nexus.In the radius server we configured the Cisco-AV-Pair attribute as priv-lvl=15, shell:roles=*"network-admin vdc-ad...
Thanks the command was right but I should enter "server" ip ssh server algorithm mac hmac-sha2-256-etm@openssh.com hmac-sha2-512-etm@openssh.com hmac-sha2-256 hmac-sha2-512
