Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all,i want to block incoming calls from PSTN for a softphone in roaming profile, below is the call flow.PSTN-->H.323 gateway (2921 voice gateway)-->CUCM-->sccp-->softphone(cisco IP Communicator) this is possilbe if my gateway is MGCP.i have ...
hi ,i have the mix environment of voice infrastructure, wherein the analog phones are connected to PBX and the IP Phones are registerd to CUCM. There is my VOICE GATEWAY on which my E1 PRI is been terminated. I can successfully dial and call the DID ...
hey guys i have a similar issue with following setup:CUCM 8.6.2 Cisco 2901, Version 15.2(1)T with uck9 technology for CME-SRST.I have setup the SRST under CUCM to point to router aswell as added that SRST service under the device pool of the 794...
earlier there was only analog voice infrastructure,i have to implement the cisco voice infrastructure so that both IP and ANALOG voice network will work simultaneously.Talking about your answer:i have un-even number in IP Phone and ANALOG phones as w...
can you tell me from which reference guide you have configure above stpes, because i have to terminate my E1 PRI line on voice gateway, so the call routing will be complex in my scenario:i have to route the call from / to:PBX,CUCM & PSTNalso , i have...
