Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,
I have a list of hundreds of URLs and IP addresses that need added to an ASA 5508-X and three 5506-Xs to get them ready. How would I go about adding these in bulk from something like a CSV file? The only approach I am seeing from the w...
We are using a McAfee SAAS solution and all incoming Emails flow through the SAAS environment before coming into our C170. McAfee --> C170 --> Exchange, when we test from the SAAS environment the connection is verified but no mail is reaching our E...
We have a new Ironport C170 and am only using the appliance for Encryption/DLP. We wish to have incoming and outgoing Email to flow through this appliance. All incoming Email will be relayed to our Exchange Server and all outgoing Email will be rel...
I have a P2P T1 between locations, each router have two ethernet interfaces, one interface is configured for communitcations between locations for our phone system. What I am trying to achive here is to use the second interface on each router for da...
Peter you were right there was a typo, i was trying to route from IP to IP and used the subnet 255.255.255.0 instead of 255.255.255.255 this was the issue, my mistake was I wanted to create a static route from network to network and thus would use 2...
