Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup clientless SSL VPN on my ASA. User authentication is done by RADIUS using ACS 5.2, I have created two portal one for IT department and the other for auditing department but the user in auditing if the select IT group from the drop down ...
Hi all,I have a cisco 6513 with 12.2(18) sxf17, my question is dose this release support MAB with 802.1x ? I was looking at the config on the switch but could not find the option to set MAB. so if it dose not support it which release would support it...
I Made that work with raduis too please look for this Doc "Group Authentication separation raduis Cisco ACS 5.2 and Cisco ASA SSL VPN"this doc has a guide about how to do that Thank you,
Ichance, thanks for the input i was able to do that with MS AD by using the "LDAP atrribute map" at that time i worked with cisco support and they show me how to do it, but this time I wanted to but this for discussion so everyone can use it if the ...
Hi all I'm having the same issue I have a FWSM running 3.1(1) when I add any ACL it took the FWSM about 7 minutes to apply it during that time the CPU hits 95% -------------- CLS Rule Current Counts --------------CLS Filter Rule Count : ...
