Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am a new student to the CCNA, I am trying to set up a basic lab. The equipment that I have is as follows:netgear (wirless/router/switch) which at this time is the only way my network is setup (I have three workstations all windows base)Cisco 3750...
I am trying to light up every port light on a 3750g. There is not anything plugged into them and I would like to know (just for fun) is there a way to make every port light 1 - 48 turn on using a command?
Does any one know if this image file has the ability to do layer 3 routing "flash:c3750-ipbase-mz.122-35.SE5/c3750-ipbase-mz.122-35.SE5.bin"Or do I need to load another image file
I know this is a very simple question, but is there a way to be able to tell if a switch is a layer 3 switch without looking at the IOS firmware? Like can you look anywhere on the chasssis to be able to tell if it is layer 3?Thanks
