Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I logged into the console of the Controller AP and show version got me this result:I recently upgraded from 8.3.133 to 8.10.185 but when it finished, the controller AP did not show up as an access point, which was previously shown when I was still in...
The key information I had to know is that the AP and WLC are two different machines having 2 different IPs. All I had to do was reset the WLC to factory settings, since I cant get anything to work via CLI, and enter the correct IP in the correct subn...
The correct subnet is the 66. I need to change the ME WLC (which is on 0.250). Based on the log files, the capwap ip of that same hardware is already on 66.171. but I can access the ME GUI on 192.168.0.250. How can I change the ME WLC to be on the 66...
May I also know if there is a command to change the ME GUI IP Address (in this case, I can access the GUI via 192.168.0.250)? And from the suggestions, I will also have to put it in the same subnet as the Controller AP (192.168.66.171, static). Am I ...
Thank you for clearing that part being the AP and ME as different machines. May I know what commands to execute to convert the settings to DHCP? I also believe that I have a lightweight setup because I have tried "configure terminal" on enabled mode ...
