Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok you pix guru's out there, I know for a router you can do many-to-one static nat translations, but how would you go about doing that on a pix firewall. I have 2 public addresses that needs to be pointed to my internet device. Thanks in advance.
To be more specific than No...Here are the Configuration Requirements and Restrictions for the ACEFollow these requirements and restrictions when configuring the redundancy feature.•Redundancy is not supported between an ACE appliance and an ACE mo...
ISAKMP: authenticator is HMAC-MD5IPSEC(validate_proposal): transform proposal (prot 3, trans 3, hmac_alg 1) not supportedISAKMP (0): atts not acceptable. Next payload is 0ISAKMP (0): SA not acceptable! Your phase 1 (isakmp) parameters went through ok...
You known that I actually ment internal and I put internet on my post, sorry about that. but typically i have set it up with routers to use two global address to one internal address going out at two different interfaces, so I get it there on how wha...
