Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am wanting to access GUI on C3850 but without success so far, I have tried Express setup by letting the switch fully boot up and pressing and holding the mode button, but nothing happens no matter how long I press it for. I have then tried setting ...
I am trying to figure out how to add an ap into a an existing EWC network currently have one ap c9130ax and I am trying to add another c9130ax both same country code, the new Ap has been reset and I believe it is in Capwap mode, currently I am unbale...
I am currently trying to convert a C9130AXI into EWC I have done a factory reset using 30 sec push of factory reset button see belowWait for the button to be released ....Button pressed for 36 secondsSetting env for full reset..Writing to Nand... do...
Thanks, a lot for the help I managed to set things up but I am getting a web browser error this site can't provide secure connection and error below in CLI%WEBSERVER-5-CONNECTION_FAILED: Switch 1 R0/0: nginx: connection failed from host 172.16.16.32...
nothing seems to happen when pressing the return it seems to just go into a capwap discovery loop see below.[*02/27/2024 08:41:25.0137] CAPWAP State: Init[*02/27/2024 08:41:29.1835] Start: RPC thread 2861753232 created.[*02/27/2024 08:41:29.1835] PNP...
Thanks for the quick reply pressing ESC key it goes into bootloader mode see below Button is pressed. Configuration reset activated..Keep the button pressed for > 20 seconds for full resetKeep the button pressed for > 30 seconds for full factory rese...
