Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,I have the following issue.I am configuring a WLC 9800 -l-f device and have the issue that the Access port is not getting the config from the controller. The AP just boots up and then flahes red and green. I think it cant get a connection to...
Just an update for everyone. The Issue was that the WLC were running Version 17.3 and with our AP's CW9164-l it needed to run at least Version 17.9. After updating the WLC's, the AP's were all discovered successfully. maybe someone can mark this as...
the weird thing is, the AP gets an IP address from DHCP. Helper Option 43 is set and in our firewall i can see that the AP contacts the WLC via Port 5246 ..but thats it. When i then check in the WLC if the AP is found, there is none. Im thinking to ...
yes of course i need only one dhcp server, but do I need to add this configuration on only one switch where the wlc is connected to?ip dhcp pool <pool name>network <ip network> <netmask>default-routerdns-serveroption 43 hex <hex-string> because the o...
i was able to figure out how to enable the SVI operational lines and also add the DHCP Option 43 to the dhcp server inside the scope options and added the hex code for my environment. but still the WLC cant see the Access Point which got an IP addres...
thanks for the link. now i setup the helper address and the AP gets finally an IP address but the wlc still cant "see" the AP. But also under the SVI, the VLAN 22 has an Admin status that is UP but Operational Status DOWN.
