Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a main LAN (192.168.0.0/), and I'm creating an isolated subnet (10.10.0.0/) that directly connects to the internet gateway (firewall). Routing between the two is handled by the firewall, and security is the sole, uncompromising priority. This ...
Hundreds of new, unfamiliar devices connect to our network each day, and I'm tasked with creating a VLAN that accesses the internet, but nothing else. I just started learning about VLANs a week ago, but I'm confident all I need is a nudge, I just don...
I'm using Aironet 2802 access points, and I'm only familiar with configuring them via a WLC. The new subnet will have one SSID and only two APs, but this number will increase substantially over time. Is there a relatively simple autonomous mode that ...
Just got it working!!!!Not a single L3 interface on the switches (ended up using older switches as I had better transceivers available, badly installed fiber SUCKS), all L2 into the firewall where I set authoritarian access rules to permit only outbo...
This is awesome. Thank you so much.I have most of this working; the AP can ping the WLC over vlan 1 even if it can't join (it doesn't seem to like the trunk port, but I don't know how to allow two vlans on an access port yet), the DHCP server is only...
This is definitely the simplest (and presumably the intended) way of doing this, but unfortunately, the network is almost entirely untagged. The only switch configured with VLANs is the one I just added, and I created vlan 1 merely to access the mana...