Why wont HSRP go beyond the INIT stateinterface Vlan20 description Zone2-6513-Blades 2-4 ip address 10.20.20.1 255.255.255.0 ip helper-address 10.20.40.48 no ip redirects no logging event link-status standby 20 ip 10.20.20.3 standby 20 priority 110 s...
Need to know how the redundant power supplies work in the 3845. At 110V the is draw 4amps, does each power supply draw 4 amps and thus the total is 8 amps for the unit or does one PS draw 4 and other 0 until failure ?
We have always ordered our 2851 with PWR-2851-51-AC-IP in case we go POE with internal switches. What show command can I use to see if the routers have these power supplies ?
yes, the VLAN interfaces are up/down. I can get them to become ACTIVE by connecting the second switch, but then where is the redundancy. If I power off one of the switches shouldn't the VLAN interfaces on the primary switch stay up/up and therefore t...
Yes, I have 20 VLAN HSRP between our redundant 6513-L3. When I setup a new Interface Vlan xx on just one 6513-L3 switch it goes from INIT all the way to ACTIVE, even without an HSRP client. The 3550-L3 switch is not behaving the same way, it seems to...
