Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I have a pure dense mode network without any active senders/receivers.Despitethis I have the following in the mroute table (on all routers).(*, 224.0.1.40), 01:55:45/00:02:27, RP 0.0.0.0, flags: DCLB Incoming interface: Null, RPF nbr 0.0.0.0B ...
I've been getting the same error message for a while:===================================Error in communicating with Group Administration Server.It may be down or not yet up. Please make sure that the Group Administration Server is up and running, the...
Hello!I have my router forwarding packets at that speed:30 second input rate 982418000 bits/sec, 91133 packets/sec 30 second output rate 982413000 bits/sec, 91130 packets/secHowever, HUM shows only 10% load on the link (I have around 936Mbit/s which...
Hello!I've been getting the following messages:1. Error in getting HUM System Summary.Please see HUMPortlet.log for more details2. Error in getting Interfcae Discards.Please see HUMPortlet.log for more details3. Histo - Graph It is temporarily unavai...
Hello!I have configured SNMPv2c and SNMPv3 Priv (SHA & AES 256) on 7609. The network seems to be correctly discovered both by using SNMPv2c and SNMPv3 (According to Device Discovery Summary all routers are reachable and their neighbors discovered). T...
Yes, the problem still persists./var/adm/CSCOpx/log/IPMOGSServer.log is emptyIPMOGSClient does not exist.Is it possible that something went wrong after I upgraded both CM (to 5.0.4) and DFM (to 3.0.4)?Regards,V.Vasilev
