Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The commands which I have found the most useful in troubleshooting voice issues on the various Cisco platforms are:'debug vpm signal' -- This will show you call setup information as well as signaling bit states on the analog leg of a call.'debug ccsi...
There are a few ways to accomplish this. Here are two:Plug a T1 loopback into the T1 port in question (this will interrupt connectivity) and send constant traffic to the IP address assigned to that port. See if the errors continue to increment.Brid...
MLPPP and MFR should work the same on these VWICs as they do on the WIC-1DSU-T1V2 et al. I've not run MLPPP on these VWICs, but I have run MFR and it works fine. Since you're using the MFT series of cards I'm assuming that you're doing standard tel...
I don't know the answer to this off the top of my head, but the easiest way to find out would be to do a 'show int switching' This is a hidden command on some IOS platforms, so you may not be able to autocomplete this command or see it in the help f...
