Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a WS-X6608-T1 Conferencing/MTP Resource configured on a 6000 Series CatOS switch. The ports of this module are configured to different call manager clusters. Due to certain reasons, some ports on this module show as unregister...
HiI have couple of users calling in and complaining that their Message Waiting Indicator is not turning on inspite of new voice messages being updated. Appreciate replies.ThanksRathish
Hi,When external users try to conference, only one user can be on a conference where as the maximum participants configured on service parameters is 15. This was working earlier. I am running CCM 4.2(2). Primary hardware transcoder is a 2821 router. ...
Hi,I work for a financial services company and plan to upgrade IOS over all the locations at once. I have discussed this with few of my collegues and they said this is OK however i am quite wary about this and prefer to do this site by site. Please a...
Hello,I have a newly configured multilink interface which is a bundle of 4 serial E1 Internet links(Effective Bandwidth 8196Mb). A VPN tunnel is configured to the other site. I have servers at 1 site trying to access the other site. A 40 Mb file tran...
Simple. Please have the value changed on your service parameters, change "Maximum Ad Hoc" value to suit your need. Also since you are using g711, prioritize your software resource on Media Resources List. This should help.
I have disabled,reset and restarted the module.No Go. Have created an RMA. 3 ports on this module is getting reset acutomatically every 2 - 3 minutes. However the other ports configured to the local CCM as transcoding/Conferencing resource is working...
An H.323 gateway does not have capabilities by itself to put calls on hold, transfer, make conference calls, etc.If you want a Media Termination Point to implement features that H.323 does not support (such as hold and transfer), you need to check th...
