Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ive attempted to upgrade my 2901 from 15.1(4)M4 to IOS version 15.4.3M8 but when I do so routes from my MPLS PE router do not make it into my routing table They show in my ospf database but for some reason are not populating my routing table. Below ...
I have a EEM script that reboots a cellular interface after 10 mins of downtime but it runs inside another EEM Script. For some reason when it runs it shows as abort. Can someone help me to fix my script so it can run successfully? below are the scr...
I just ran a portscan on my asa firewall and noticed that the ports listed below are open on my outside interface. My problem is that I am not using any of these ports and have not firewall rules permitting them. Any ideas on how to close them?
2000...
Hi,Ive been setting up locations in my topology map and just recently added my WLC and APs. The devices have successfully been added to the device inventory but for some reason when I add them to my Main Office location I am unable to see them in the...
Hi guys I have configured EEM to track an object based on IP SLA. It basically resets my 4g interface if my SLA goes down. It works perfect but only initiates one time when the triggered condition is met. What I would like to know is if there is any...
Hi the APs that are in Flexconnect mode are currently showing in the topology map in their designated locations. Its the ones that are locally at my HQ that arent showing.Also, the WLC isnt showing in the map either which is bugging me.
Yes CDP is enabled. The only difference between the AP's that show and the ones that done is that they are using flexconnect. Its rather strange that the WLC doesnt show at all either in the Topology Map but all the devices show in the device invento...
