In the last couple of deployments our APs lost their name when reconnecting to the 9800 after initial staging. This has happened whether we changed the name in the GUI or via the console on the AP.
Anyone else seen this behaviour?
I am trying to understand Guest Anchoring with the 9800 Controllers.
In the 5500 series WLCs you had to access the WMI from the inside network through the firewall to the Anchor Controller Mgmt Vlan on a DMZ. Then create another sub-interface on the...
There is not one mention of a firewall/DMZ in that support doc. It does show a diagram of the Forgein and Anchor connecting via the internal network and then a link to the Internet from the Anchor. That document lacks so much detail.
