Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have connected a third-party SIP device (Yealink) to CUCM and attempted to configure the call forward option on the Yealink phone.However, call forwarding fails to transfer calls both to the correct internal extension and to an external phone numb...
HiI have Cisco Call Manager v12.5 and have set the Busy Trigger to 2. In this setup, if someone tries to call me while I’m on another call, they aren’t notified that I’m busy. Is there an option to either notify the caller that I’m on another call, o...
Dears.I Have Avaya K175 configured as SIP on Cisco Call Manager.the phone keeps disconnecting every 2- 3 minutes.I can make calls from Avaya phone to Cisco phones. but Avaya is not receiving from Cisco " gives busy tone".I checked Cisco & Avaya logs ...
Dears;can I configure Avaya K175 Model (K175D02A), as 3rd party SIP.Avaya K175 with loaded firmware (K1xx_SIP-R2_2_0_6).46xxsettings.txt configured as follows:SET SIPDOMAIN (CUCM DOMAIN)SET SIP_CONTROLLER_LIST (CUCM_Server_IP):5060;transport=tcpSET ...
Hi Nithin,Regarding your questions:1. Could you please provide more details about the call flow?A call is made to a phone with a specific partition already defined. The destination phone should forward the call to another internal extension on the sa...
In this case, I think that the best approach would be to use Unity Connection and set the busy trigger to 1. Then, configure a Busy Greeting on the voicemail box to inform users that you are on another line.am I correct?Kind Regards,
Hi Maren,Thank you for your response.I am interested in a scenario similar to a system found in other setups, for example, Alcatel-Lucent. They have a system where, if a call comes in while the line is busy, an automated message indicates that the li...
