Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone.Hope this is in the right section, first post since things were merged.I need to cleanup our webhook receiver list that is located under Organization - Monitor - Alerts. All I can find is articles on how to clean then up under Organizatio...
Looking at the documentation for the C9300L it says it can do NetFlow while in Meraki mode. I have it setup but not seeing any data getting to our SolarWinds server. Thoughts?Thanks
Good MorningTrying to configure the SNMP settings for a Meraki managed Cisco C9300L switch. It is enabled under organization but no option under network like there is for Meraki switches. Please advise on how to configure. Thanks in Advance!Ed
Good Morning!I am trying to apply a switch template. I have the template setup and attached to a network. When I claim and add a switch to that network shouldn't it automatically apply the template? If so, mine isn't doing that. Thoughts?ThanksEd
Good Afternoon.We are seeing an ongoing error on some of our APs. The error is telling us we have a misconfigures DNS but these APs have the same exact configuration as the rest of the APs. Any ideas on what could be the cause?Thanks in Advance!Ed
Good MorningThanks for the replies....these are being managed by Meraki Cloud so there is no CLI to check unfortunately. I believe the normal Meraki switch need to have their NetFlow sent to a public IP and I also believe it says it on the config pa...
HI @alessandrodematos Thanks for the quick response.I understand that the template gives a basic configuration for the switch and then to tweak specific setting changes but the switch isn't even getting that basic set of settings.Ok wait I just notic...
