Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have an internet vrf that has only a default route(i don't want internet routing table) but the problem now is when i make customer member of this VPN (internet VPN) they will be able to route to all other customer (on other VPNs)through the int...
Hi Guys,Can anyone tell me the maximum number of IBGP peer i can have on a 3750 with EMI? the maximum number of routes i am looking at is 400 routes (small) but i am looking at a up to 100 peers. bandwidth usage too will be small (max will be 200MB)c...
HI Guys, I need to use 3750 for a lot of BGP sessions. the maximum routes will be around 500 but there needs to be about 100 IBGP sessions on just one 3750. there won't be problems with configs 'cause i will be using peer group but i don't know if 10...
Hi guys,I will like to know if on the accesslist with PAT, you can have deny statements. i.e deny statement as part of the access-list for traffic you don't want to be PATed.example:access-list acl-pat deny ip 10.0.0.1 0.0.0.0 any access-list acl-pat...
hello guys,i have a particular problem with my VPN concentrator behind PIX. i am doing a PAT and all traffic goes out from everywhere being PATed properly. except my esp (protocol 50) traffic. i get this message. even though i can get to the internet...
Hi, cisco seems to have fixed this problem in 7.0 version of PIX os pls look at this linkhttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804675ac.shtmlrate if it helps
Hi,This may not be possible using PIX. PIX does not route traffic received on one interface back out the same interface. so inter-spoke communication is not possible. two things u can do.1. do a full mesh IPSEC config for spoke that need to communica...
Well, I didn't want to use access-list on the wan interface facing the MPLS cloud. access-list at times gives CPU problems (depending on traffic and on the platform)Regards,
Good Man! I thought of this. (using PIX) but i can't use PIX because i have BGP as the PE-CE routing protocol and PIX doesn't support BGP.I also thought of another solution. Using PBR (Policy Based Routing) saying anything coming for the MPLS VPN int...
