About casealves

casealves · 06-10-2015

I can´t use the telepresence when the origin use NAT.If it use a public IP as the source, the conection is closed normally.The question is: how can i use a NAT in the source? Thanks.

casealves · 05-21-2015

I´m trying to configure a telepresence SX10, but it is showed the error above.Is there any way to configure without the SIP authentication? Error: Call Protocol RegistrationThe system is not registered on SIP. It will not be able to place or receive ...

casealves · 06-15-2015

Hi Moyo, let's go.I´m using a standalone SX10.If i use Any Telepresence with a public IP X SX10 with NAT(Public + Private IP), it works.But if i use Any Telepresence with NAT(Public + Private IP) X SX10 with NAT(Public + Private IP) it doesn't work. ...

casealves · 05-28-2015

The SX10 works as a stand-alone.The problem was the software phone i was using, because that was working with H323.When i turned to SIP, the SX10 accepted the communication. Thanks.

Member Since	‎05-21-2015 05:26 PM
Date Last Visited	‎06-21-2023 03:27 AM
Posts	4

User Statistics

User Activity

SX10 with problem when the source use NAT

SX10 - Call Protocol Registration

Hi Moyo, let's go.I´m using a

The SX10 works as a stand