Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Can someone tell me if I can build a stack with two 3850 SW running on IP Base feature but have different physical port configuration?
On Cisco guide the only conditions are regarding same IOS and licensing but doesn't have other requirements...
Hello,
I have 3 days searching on the internet and still no information about this. I have bought a Multi Layer Switch 3560 for lab environment and need to upgrade since the exams now operate on IOS 15.
Cisco official site: Note that the following mo...
Hello
Thank you for your response and the detailed information.
Yes, I did saw many documentation not excluding this scenario but I have to be sure before making the order for this 2 Sw. Does anyone tried this on real equipment on production?
Thanks
New update I tried a new flash ipservices family: c3560-ipservicesk9-mz.150-2.SE8.bin and it worked.
Now the switch show version:
SW1#show versionCisco IOS Software, C3560 Software (C3560-IPSERVICESK9-M), Version 15.0(2)SE8, RELEASE SOFTWARE (fc1)Tec...
As you predicted, it just start load the new flash init uncompressing and than give the error: Error loading "flash:c3560-ipbasek9-mz.150-2.SE8.bin" and than goes back to the old flash and boots normally.
So the final conclusion is Cisco doesn't allo...
Hello,
sorry for asking here but I have 3 days searching on the internet I have a ML switch for lab enviorment and need to upgrade since the exams now operate on IOS 15.My cisco model is: WS-C3560-24TS and my memory 32514048 bytes total (22032384 by...