Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is enabling a routing protocol a necessity for GRE? Can you direct me to documentation for configuring/enabling GRE on a Remote Access VPN on a PIX 515E?Thanks
I'm trying to get a server in my DMZ to talk to servers on the inside. I created an ACL to allow for this, but I keep getting this: Jun 23 2006 14:28:18: %ASA-3-305005: No translation group found for udp src DMZ1:10.3.200.100/8111 dst INSIDE:10.3.1.2...
Hello,1. Is there a way to create a site-to-site tunnel but only allow one side to initiate the tunnel?2. Can you NAT across a VPN tunnel? If either of these is possible, could you point me to configuration examples or documentation on how to accompl...
When I remote access VPN in to my ASA, I can't ping devices on the other end of a site-to-site vpn. One of the reasons for puchasing the ASA was for this reason. When I enable ospf it doesn't show the other ends network either. Can you help?
No problem. Sorry about not responding sooner, I was in a small car accident, so I've been a little busy, but all is well now. I'm glad it worked for you.Chris
I have to say, it does look like your internal network encompasses the remote access pool. Have you tried changing the pool to say 10.20.0.0/16? I'll look at it closer later.
Bad and Worse news:Bad: PIX's not running the 7.0 series can not route traffic out of the same interface the traffic is recived. Version 7.0 resolves this for ipsec traffic.Worse: PIX 501's can not be upgraded to 7.0...A couple of things to think abo...
