Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,I have been told that implementing MST does make the use of spanning-tree portfast unnecessary. As far as I can see, even after configuring MST, the forward delay and maxage timers are still the same as with PVST, that is, 15 and 20 se...
Hello all,I have a problem with the CPU utilization on my Cisco 7206VXR router. The 'Pool Manager' process is consistently using about 40% of the CPU. I cannot really figure out what is using this process. I did a bug search for IOS 12.2(17a), but ca...
Hello Sly,are you connected to the router through the console port ? If so, try to change to different speeds on your Hyperterminal (or whatever you are using). The 'rubbish' characters you see usually come from a speed mismatch...HTH,GNT
Hello,have a look at this very good explanation from a user on the volocityreviews forum:"There are some advantages to having a L3 etherchannel rather than having equal cost paths seen by L3 as two separate links. Forinstance, imagine that one of the...
Hello,are both public IP addresses from the same provider ? Can you post the full configuration of your router ? Also, do you want to have your internal addresses translated to both public IP addresses ?Regards,GNT
