Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I try to use a DECT phone with my SPA-2102. When a call is finished and the user of the DECT phone (Gigaset E630) forgets to end the session by pressing the red button (hook on) than the phone stays off hook for inifinite time.
The base of the G...
Hi,I am using a device that acts as a door speaker system with 'ab' interface. It works quite well, but as the phone inside the house is hung up, the busy tone is received by the device but not detected. So the device didn't hung up.The company tells...
Hi,I try to setup an ATA to use my analog FAX machine over VoIP.Situation: Brother 7225N FAX machine, PAP2T oder SPA 2101, Ethernet, 3CX PBX - software, Patton 4552 Gateway to ISDN public network.Result: Phone works, FAX receiving works with SPA 210...
Hi Dan,
ok, we have two cases.
1.) I call the DECT phone. After stop talking I hook on my phone but the user of the DECT phone do not. First he hear a busy tone and than the hook off warning tone. After that the DECT phone is off hook for infinitife ...
Hi Dan,
thanks for the answers.
After the party not using the DECT phone and the ATA hungs up I hear the busy tone in the DECT phones speaker. After some seconds I hear the hook off warning tone, both were generated by the ATA. I know this, cause I c...
Hi,
whatever CPC is, it doesn't work out.
My Settings: CPC-Delay = 2; CPD-Duration = 5
The phone stays off hook for 3:46 minutes now, and yes I have saved the new config.
As I wrote (in my bad English) The ATA has to actively cancle the call by i...
Hi Giordano, my country is Austria. I found out now, that the 'Reorder Tone' is played, and I found correctsetting. As I need only one tone played, can I use 420@-10:15(.5/.5) for 420 Hz at-10dbm, for 15 seconds, on for 500 msec and off for 500 msec?...
