Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello, if i have one vlan configured exp:vlan 100 , and i need to carry the vlan between SW1=> SW2 =>SW3 , the vlan is defined on all the 3 switchs the interco between those switchs need to be trunk or access ? , even if its only one vlan?
Hello,I have a stack composed of two Cisco Catalyst 9200 switches. Currently, only the management port of the active (master) switch is connected to a management switch, while the management port of the standby (member) switch is not connected.From m...
Hello, I have a Cisco ACI environment with two leaf switches connected to two firewalls: Firewall Edge1 and Firewall Edge2.
I created two L3Outs:
L3Out_FWEdge1: provides access to Network A (NetA) via Firewall Edge1L3Out_FWEdge2: provides access to N...
hello , i have ACI operating as pure Layer 2 and the servers’ default gateway is on the firewall. The firewall is connected to two ACI leafs using a vPC that is already configured for an L3Out (SVI + vPC). i have created two domains, one for bare m...
helle , i have ACI operating as pure Layer 2 and the servers’ default gateway is on the firewall. The firewall is connected to two ACI leafs using a vPC that is already configured for an L3Out (SVI + vPC).
Do I need to use that same firewall vPC to ...
so i dont need to specify the type of the link ( access or trunk ) like this : int g0/0 #switchport switchport access vlan 100 without switchport mode access ? will it work ?
Thank you . so i need to connect both management port for both members into the management switch then in the configuration i see only one G0/0 this is tied to the master node , now if i give this interface an IP , and the master will go down then t...
