Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I use uBR10k - 5x20 cards -configured with External EQAM for bonding downstreams. This is my Sh Cab modem output for lab setup.uBR10k#scmMAC Address IP Address I/F MAC Prim RxPwr Timing Num BPI ...
I have two different LMS 3.1 servers at two different locations.1st @ Site A &2nd @ Site 2Both have diffrent (site spacific TACACS+) ACS servers. Now I want to monitor Site A DFM alerts from Site B LMS Screen. What are the ways to do that & any extra...
My topology maps shows a lot "RED" links. Above image shows an example.A link shows error is explained. Location 1 is connected to location 2 where link speed mismatch is shown by Topology map - link report.Now actually when i login to these two dev...
Log file DirectoryFile Size (KBytes)Recommended Size Limit (KBytes)File System Utilization%jrm.logC:\PROGRA~1\CSCOpx\log1070841024Less than 1%stdout.log.*C:\PROGRA~1\CSCOpx\mdc\tomcat\logs57591102400Less than 1%dbbackup.logC:\PROGRA~1\CSCOpx\log11772...
I want to have an external logfile which should write "DEVICEName & respective Interface" at the event when this port goes down. Actually i want to monitor all uplink ports in this way.
Hey Marco, Thank you for confirming it works on 5X20S in your Lab.I m happy ..Now my purpose to switch IOS is: (of course i can execute more commandsets) 1. Find SNMP oids from DOCS-IF3 mib (supported on SCE6) to check my modem is locked on howmany ...
Hey Marco,I have ubr 10012 with ESR-PRE2 engine, SPA-24XDS-SFP and line cards UBR10-MC5X20S-D line cards.. Will SCE6 work on my box ? does it support MC5X20S-D line cards ? SCE6 supports PRE2 engine but i couldn't find MC5X20S-D compatibility informa...
Hi Marco,Thanks for the update.so i conclude with : We should consider release date (for the latest) of IOS while selecting IOS. correct ?Thank you for the support!Regards,Bhavyang
Hey Marco, Retirement table doesnt show 12.3 23 BC10 . Now if i browse Development tree, i get following. Under latest it shows 12.3 23 BC 10 as latest one. how do you suggest ? by release date ? as release date of SCE6 is the latest i.e March 2012...
Hey Marco, 1. Modem Web interface status page says its locked to 4 downstreams. (primary, bonded1,2 &3) ... and it also turns its DS status LED blue (Docsis3). 2. I have gone through releases.. I use 5x20 card & Pre-2 card and i feel Release 12.2.33...
