Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to know how to bypass startup configuration for WS-C4510R-E model switches. I am able to access ROMMON. Where do I go from here? Again I need the instructions for WS-C4510R-E specifically as they are different from the WS-C4500s I...
Hello, First time posting on this forum. I am having difficulty erasing the startup config on a Catalyst 6500-E switch. I'm able to get into ROMMON via ctrl-break sequence, but once there I'm at a loss for what to do. I tried changing confreg to 0x21...
Hi all,I have locked myself out of the switch, more specifically, I can't enable. Every method of password recovery I have tried has failed. I do not know how to factory reset my two stackwise-enabled switches. I need a password recovery procedure th...
Here is the entire output: ********************************************************** * * * Welcome to Rom Monitor for WS-X45-SUP6-E System. * * Copyright (c) 2003-2009 by Cisco Systems, Inc. * * All rights reserved. * * * ***************************...
Did not work. Type control-C to prevent autobooting.. . . . .******** The system will autoboot now ********config-register = 0x2102Autobooting using BOOT variable specified file.....Could not find a valid file in BOOT environment variable.BOOT variab...
Okay that did not work:rommon 14 >setPS1=rommon ! >RommonVer=12.2(44r)SG5CV=PV=SV=IS=BOOT=bootflash:cat4500e-entservicesk9-mz.152-2.E8.bin,1;RET_2_RCALTS=BootedFileName=bootflash:cat4500e-entservicesk9-mz.152-2.E8.binConsecPostPassedCnt=4ConfigReg=0x...
Okay so I was able to set the confreg to 0x2142 using the following prompt choices: rommon 13 >confregConfiguration Summary : => diagnostic mode=> use net in IP bcast address=> load rom after netboot fails=> use all zero broadcast=> ignore system con...
