Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have found many articles related to the Cisco 8831 device pack. I have purchased a few of these conference phones recently. I installed device pack cmterm-8831-sip.9-3-3-5.cop.sgn and restarted the whole cluster. My version of CUCM is 7.1.5.35901-1...
Recently our CEO wanted to get a Cisco 9971 phone to use at his desk and purchased the phone. I have CUCM 7.1.5 running SCCP. The phone is a SIP only phone. Is there a way I can add the 9971 to my environment without drastic changes to my environment...
Mohammed Noor,Thanks for the information. I new it had to be something basic! My brain went left and I needed it to go right if you know what I mean....Todd
I was able to get it working by completely removing it and adding it back in CUCM. I will have to add the SIP commands to the router for fallback to work yet. Thanks for your help though.Todd
Thanks for the quick reply! I have tried adding the file and phone is getting an error about not being able to find the XMLDefault.cnf.xml.sgn file. I must have to install the COP files or something.
How high are your antennas if you need a lift? Antenna type and placement?Proper antenna configuration is a critical factor in maximizing radio range. As a general rule, range increases in proportion to antenna height. However, do not place the anten...
