Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am getting the error on my switch when I connect my PoE phone, I would like to know how to have the port send power to the phone. When I check the other ports on the switch that has power is outline below. ErrorInterface Gi2/0/48: Power Device dete...
I have a ASA 5505 and setup SSL VPN. My users can connect to the VPN but can't get access to any of the internal servers. Can someone tell me what I am missing?
I have change my NAT rule on my ASA to a diffrent public IP address, when I try to access the server from the internet it takes about a hour to reply. Can someone tell me why when I change the public IP in my NAT rule it takes that long to start repl...
I have set up a static NAT rule on my ASA to a web server. I have have users accessing the internet using the outside interface. How do I get the web server to only use the public IP I did the static NAT with to get out to the internet? when I try to...
The public IP I change it to was taken from a server that had it, the DNS is still the same. I just remove the server and use that public IP in the NAT rule. I can't even ping the IP address after the change but I can ping other public NAT IP.
Thanks guys I got it fix, I did not get the routing on the router right. No I am not the end users and not all the time it is good to jump and get a consult.. on every little problem...
