Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a remote VPN host via Anyconnect that can reach my LAN resources without a problem; however, there is a server application that must initiate sessions to the remote host and it cannot.Hosts within my LAN cannot ping or connect to the remote ho...
My ACE is almost completely configured - with VIPs, farms, real servers, redirects etc. Port 80 and 443 are working as expected and web requests are getting routed appropriately. The need has arisen however, to allow a non-traditional port to be allo...
I'm trying to route all default traffic from my production environment through my ASA 5520 on the "outside2" interface.The 5520 has a site to site VPN to our DR site on the "outside/inside" interfaces via one ISP. On another ISP, interfaces "outside2...
Please see the included diagram.I need to move the client machines off of the 3750 (and their DHCP dependency on it) to the SGE2010 and absolutely route their internet traffic out through the outside interface on the 5505. They must also be able to c...
Please see the included diagram.I need to move the client machines off of the 3750 (and their DHCP dependency on it) to the SGE2010 and absolutely route their internet traffic out through the outside interface on the 5505. They must also be able to c...
Genworth/all,I am in the process of doing a very similar implementation to the one you mentioned here. I too am still a little uncertain about the physical topology of the device installation with regards to the firewall and switches. Do you have an...
Varun,I'm anxious to try your suggestion, but I don't think i'm using the right commands in the CLI or configuring it correctly in ASDM. I apologize for my limited knowledge but could you reply with exact syntax?Thanks
I was able to resolve this by directly connecting the ASA 5505 and the SGE2010.1. I put an IP addresses on the SGE2010 in the same subnet as the inside interface IP on the 55052. I put that eth2 interface on the 5505 in the same vlan as the rest of m...
