Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Day CSS Experts, I am configuring CSS 11503 in VIP and Virtual interface redundancy. Client----L3S/w--- CSS1----CSS2 -----L2 (stack)--server1 I have understood that rather using upper and lower device ip for monitoring, we should use CSS interfa...
Good Day, I am soon going to implement CSS 11503's in redundancy with session stickiness. Request the experts review on the configuration. The config with a diagram is enclosed in the attached document.Many Thanks,gagan sethi
Hi AllHave few queries to be verified:1. With VIP & Virtual Interface configuration & couple of server VLAN's below the CSS on server side, I should be able to use both the gigabit interfaces on the 11503 to connect up and down streams as TRUNK. I me...
Hi all, I am designing a solution at the moment, in which I shall have 2 servers behind a pair of CSS & their default gateway will be the Virtual Interface ip address of CSS.Is there any problem forseen in traffic getting initiated from the server to...
Good Day, To check the maintainance mode version, I have to boot into the maintainance partition of the FWSM. Will this reload my FWSM or hamper the production N/w? Is there any other way to check the maintainance mode version ? Thanks Gagan
Good Day, Any suggestions on the above shall be appreciated.Also, do i need to have critical service and critical reporter configured on the standby CSS as well ? Thanks,Gagan
Good Day Gilles, Thanks a lot for the explainations.1. I intend to do failover if any srvice/Gw/intf goes down.Is this config correct for Intf/srv.********************reporter both-inttype vrid-peeringvrid 192.168.1.200 1 <-- For servicevrid 192.168...
My intention behind posting the query was the worry for layer 2 switch failing situation.I must say this is THE answer i was looking for. Many thanks Cheers,Gagan
