Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,How do we configure a "tag" value under a content rule to enable it to respond to the GSS initiated queries.On the GSS I just configured a "KAL-VIP by tag". This is a shared keepalive against a CSS circuit address. I give a tag a value here. I nee...
On an SSL termination and SSL initiation on a CSS in redundant active/backup mode,1/ Does it that necessary to add the VIPs of the back-end content rule (meant for proxy-list use), under the circuit's virtual-routers.2/ How harmful if we use a non-ro...
Hi,A new requirement with our client to run Instant Messaging (chat) servers behind CSS. Need to load balance between pool of "Microsoft Live Communications Server 2005 with SP1 Enterprise Edition". Have anyone tried these servers behind a CSS? What ...
What is the 'key' difference between the basic src-ip method and the advanced sticky src-ip methods? I can understand in the advanced one, CSS actually "sticks" a client to a server based on the client's source IP address.I can understand the basic o...
May be that I understood the least connections concept wrong.When I use basic load balancing like least connections in combination with an adv bal sticky method, does it mean a brand new session with out any sticky component, will just be applied bli...
Yes. You do not need one if you don't open the encrypted packets. In reality this doesn't work and you will be heading up to a point of no return after making a huge investment on a CSS box that doesn't support SSL termination. We got couple of boxes...
In a single-armed config, both web server/client PC are sitting on the single VLAN.By default, the nature of the CSS is to "spoof" the client PC IP addresses to the web servers. Due to this spoofing, web servers thinks that they are actually talking ...
Gilles,When you say the following in quotes what exactly did you mean. You say for udp, things are different. If it is a TCP or UDP it doesn't matter to the CSS. You still need 2 groups. One group to do client NAT-ing the inbound and another group to...
Much talked about topic. The CSS spoofs the client browser ip to the servers that it load balances. To stop this default behaviour configure "add destination service " under the group config. Drawback is you would see CSS circuit address as the sourc...
Just type your new ip address under the circuit VLAN. See below. It will accept the second ip address as well. I never used these sort of assignments in production deployments. I presume it would be similar to putting a secondary ip address on the ro...
