Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All.A client of ours have a couple of MXs that are due for a Firmware upgrade, but they all have the following message note.This network contains device(s) which are incompatible with the target version. Their firmware version must remain below MX...
Hi All.We have a MR36 AP on firmware 30.6 connected to a MS120 switch.The AP is online and working but shows offline in dashboard.I can ping the AP from the switch.Dashboard message:This device may be unplugged, or it was connected to a new device as...
Hi all.We have a client running MR 29.5.1 on all their AP's.It was recommended for them to upgrade to MR30.6, but I see that MR 30.7 has been release.Will it be better for them to jump straight to MR 30.7, or do they need to upgrade to MR30.6 first?C...
Hi All.I'm new here. I have a question regarding licenses per device. When a device (AP) is not online does it consume a license?AP's that are attached to a site and offline (Basically they are spares)Do they use a license or only when they are onlin...
Hi all.Was there a solution to this issue. Sitting with the same problem.AP is in mesh mode. Full Factory reset (30+ seconds mode button) does not do the trick. Once it boots up it goes straight back to:*07/08/2024 00:01:46.1653] DOT11_DRV[0]: Channe...
Just saw other post with the same issue.Ref for anyone coming across my post.Solved: Re: Firmware Restricting Warning for 18.200 on older MX's - The Meraki CommunityProduct Firmware Version Restrictions - Cisco Meraki Documentation
Hi all. Just an update. Meraki ended up doing an RMA of the AP as we could not get it working as it should.I've just added the new ap and it is working. Thanks again for all the responses.Cheers.